Martin Logan  Dynamo 1000W  12”吋 超低音  規格表

■ 喇叭單體 ＆ 單音箱型式
超低音單體　尺寸規格：(？吋) （Super Woofer Driver）	12" (30.5cm) high excursion, poly cone with extended throw drive assembly; sealed non-resonant cabinet design
超低音單體 單體數量：(？支)
單體設計材質：（例：鋁製夾心圓錐）
主動式 or 被動式 系統
頻率響應　？Hz ~ ？kHz 數值範圍 ( Frequency Response )	22–200 Hz ±3dB; Anechoic through LFE effects input
設計型式 1：低音反射式 / 密閉 氣墊式
設計型式 2：低音單體~正面發聲 / 低音單體~向下發聲
設計型式 3：✔ 推挽式
■ 擴大機功率 ＆ 頻率範圍調整 ＆ 輸出入端子
擴大機 輸出功率 ( RMS / 峰值 ) ？瓦	500 watts (1000 watts peak)
頻率響應　？Hz ~ ？kHz 數值範圍 ( Frequency Response )
✔ 低通濾波 ( 連續可調 )	✔
✔ 低通濾波 ( 使用 無線介面 App 調整 )
✔ 相位選擇	✔
輸入端子：RCA x ？組 ／ 高電位 x ？組	Left and Right/LFE RCA line level
輸出端子：RCA x ？組 ／ 高電位 x ？組
✔ 自動電源啟閉  　( Auto Power )
■ 外觀型式
外觀顏色 ( 表面材質處理 )
外觀尺寸 ( 高 × 寬 × 深 mm） ( Dimensions ( H × W × D mm))	Down-Firing Orientation 369 x 348 x 371 mm Front-Firing Orientation 393 x 348 x 364 mm
淨重： 公斤　kg 數值 （ Net Weight / kg ）	15.4kg

•Martin Logan Dynamo 1000W 超低音 規格表

頻率響應 22–200 Hz ±3dB; Anechoic through LFE effects input 低通瀘波器頻率 35–120 Hz 低頻轉換器 12" (30.5cm) high excursion, poly cone with extended throw drive assembly; sealed non-resonant cabinet design 放大器 500 watts (1000 watts peak) 阻抗 Line level RCA: 20,000 Ohms 音頻控制 Low Pass Filter Switch: Bypass (LFE In), Variable (Left and Right In) 相位控制 0°, 90°, 180° 輸入 Left and Right/LFE RCA line level 功率消耗 Standby: 1W Idle: 15W Max: 650W

無線功能 Built-in receiver and included SWT-2 transmitter ■ 解析度 16-bit ■ 採樣率 48kHz ■ 無線頻段 2.4GHz uncompressed digital self-sensing design constantly adjusts for best connection. ■ 錯誤檢測 Bidirectional feedback constantly monitors integrity of data stream. ■ 天線 Internal ■ 發射器對應數量 One ■ 最大無線範圍 30–40 feet (10–12.5 meters) 重量 15.4kg 外型尺寸 (高 x 寬 x 深) Down-Firing Orientation 36.9cm x 34.8cm x 37.1cm Front-Firing Orientation 39.3cm x 34.8cm x 36.4cm

Martin Logan Dynamo 1000W 超低音

● 無線主動低音
● 12"低音單體
● 輸出功率 1000W (峰值)
● 低頻下潛 35Hz

Dynamo 1000w超低音喇叭值得多注意，使用12吋單體，出廠設定為朝下發射，用家可以自行改成朝向前方，只要把腳釘變換位置即可。內建擴大機輸出功率500W，瞬間輸出可達 1000W，應付影片中突然出現的大動態音效也不會軟腳。同時，它具備無線傳輸訊號功能，只要把訊號線接到SWT-2發射器上，就可以無線方式傳送訊號過去。

▍超低音喇叭具備無線傳輸

有人說無線傳輸將是未來世界的趨勢，對Dynamo 1000w來說則是現在進行式，透過無線傳輸的發射器，就能解決訊號線的問題。拉一條訊號線哪會有問題？有些用家受到空間限制，超低音喇叭必須擺在離環繞 擴大機很遠的距離，此時就必須拉一條很長的訊號線過去。相信大部分人難以在裝潢時，就預想到要先埋入這條訊號線，導致線材外露。如果無法接受此狀況，把線 材連到SWT-2發射器就可以了，它還會自動對頻，使用起來毫無困難。

Powerful Dynamo Subwoofer... Ideal for Larger Rooms!
True high-end performance. Home-friendly aesthetics. And power, lots of power! In a nutshell, that's the incredible Dynamo 1000w subwoofer. Dramatic bass detail, bass attack, superb extension and room-shaking output ensure a music and home theater experience like no other subwoofer in its class can deliver. Features include a 500-watt RMS, 1,000-watt peak amplifier and 12-inch cone driver. Its standard down-firing configuration quickly (and easily!) converts into a front-firing configuration, ideal for discrete installations. Finishing touch... an included wireless transmitter and receiver for a 'cable-less' environment.

 
Built-In Wireless Receiver offers Extreme Placement Flexibility!
Although correct placement plays a key role in optimizing subwoofer performance, sometimes it imposes the inconvenience (not to mention unsightliness!) of running long lengths of cable through walls, along baseboards or under floors and carpets. To solve the problem, the Dynamo 1000w incorporates a wireless receiver (digital RF transmission) for use with the included SWT-2 MartinLogan Subwoofer Wireless Transmitter in which case, cable clutter also becomes a moot point!

High-Resolution Low-Distortion 12-Inch Woofer
The Dynamo 1000w's advanced-technology driver pairs a high-power magnet structure with a 12-inch diaphragm to deliver huge excursion and sound output while perfectly preserving the tiniest bass detail -- and all without a hint of distortion. The exceptional damping properties of the cone material also ensure the smooth, non-resonant response necessary for truly seamless blending with MartinLogan electrostatic panel and Folded Motion? driver technologies.

Advanced Ultra-Efficient 500-Watt Amplifier
The Dynamo 1000w's ultra-efficient high-power amplifier uses variable audio tracking power supplies to drive its class AB output stage. With lower distortion and less noise than typical Class D switching amplifiers this advanced design allows the amplifier to operate at much higher efficiencies than a typical class AB amplifier, delivering a true 500 watts of continuous power. An energy-conscious design, the Dynamo 1000w's amp consumes less than a single watt in Standby mode.

 
Front-Firing or Down-Firing Configuration
To maximize performance when installed inside of a cabinet or other discrete installation, the Dynamo 1000w's standard down-firing configuration easily converts into a front-firing orientation-no tools required! A grill cover and 90 degree RCA adaptors are provided for use in front-firing applications.

 
Inverse Mathematical Equalization (IME) Filter
An IME filter is derived from the inverse of the unfiltered driver response. Precision IME filtering yields extremely accurate low-frequency response - far superior to that provided by the simple second-order high-Q filters typically found in subwoofers in this price range.

Sealed Cabinet with Extensive Internal Bracing
A good sealed system will typically exhibit less transient-blurring group delay while maintaining smooth, consistent response regardless of music or movie source material. On the outside, the Dynamo 1000w's cabinet is constructed from the finest composite material for acoustic integrity. Inside, critically placed structural cross-bracing acts an excellent baffle for the woofer while the added rigidity keeps cabinet-induced resonances and non-linearities to inaudible levels.

Seamless System Integration - Engineered for Stereo and Home Theater
Comprehensive connection options, low-pass filtering and phase control make integrating the Dynamo 1000w subwoofer into a multi-channel home theater or stereo music setup simple and seamless. The main left/right line-level inputs feed into a precision low-pass filter with a cut-off frequency variable from 35 to 120 Hz. For systems in which a surround processor supplies the crossover, the Dynamo 1000w offers an LFE input that bypasses its internal filters.

Energy Transfer Coupler (ETC) Spikes
The Dynamo 1000w comes with custom ETC spikes which can be used in place of the feet to enhance stability on thick carpets, or create tighter coupling between subwoofer and floor to enhance overall sound quality.